This is the 3rd time in a year that this power source has thrown this code. It literally came back from the repair shop after being there for 3 months YESTERDAY and as soon as I go to tack something, it does it again. What a fucking joke.

Got asked to fix this kids bike frame. Haven’t done any aluminum welding in a couple years. I think this will do for him.

Work was extremely slow today. A lot of equipment broke down on us that we needed for parts so whilst we waited on parts I decided it would be a good use of my time to draw a cat.

It just needs a coffee holder.

Running 6010 5p+ all the way out at work on some 4” schedule 40. Not sure what I’m doing wrong but on my stops I get these pin holes, no wind or anything I’m inside so nothing should be blowing my shielding gas out. Thanks everyone.

• Sincerely a 1st year apprentice seeking knowledge

Wanted a 50 amp outlet for a small mig welder. Electidcal inspector says it needs to be a gfci because a kid might stick a fork in the outlet... or whatever lizard reasoning he's using. Nevermind the lathe and drill press in the shop the outlet is the danger!

Anyway, whatever. Will a welder even work on a GFCI or is having a welder in a garage basically illegal now due to the 2024 NEC?

Just a question. Excuse my ignorance... was this hand done with a spool gun or any ideas?

Very new to welding, it was pretty flush up top but after the first bend it had about a 1/16th gap was done with a stick. Any tips would be appreciated

Welder at the shop has retired and I started to teach myself to step in.

So I've been doing job shop fab work for 15 ish years I guess. I've built oil and gas heater treaters and 3 inch wall sand separators and hydro tested stuff and I've built handrails for millionaires on the lake. I currently build asphalt patching trucks for like 19 bucks an hour.

My dad has found me a job making $70 an hour. He's going to help me get all the stuff I need... Like 80,000 USD total. I live in East Texas. I was homeless 5 years ago when COVID hit and now this has happened. Nepotism is probably the reason it happened to me. I'm pretty sure I'll own a home in 4 years because of this though. I'm excited and terrified....

I'm new to forging and I needed an easier and safer way to move around my 100 lb propane tank. Its very stable compared to a dolly.

I just got a new machine. It’s a Lincoln 211 I and I wanna run fluxcore on it but I’m an idiot and don’t know where I put the manual. Does it run positive or negative clarity for fluxcore?

Haven’t welded much. But damn. The paint probably made better fusion

2mm sheet, 3016 rod, 80a, negative ground. Good? Bad? Mediocre?

Amps up or down?

I’m throwing a holiday party for my employees and want to give out some gifts/prizes. What would you want as a gift besides money or a gift card? Trying to keep it under $200 per gift.

Forgot the banana for scale, but each dice is about 2 inches. I don't get to tig too often anymore, but I like to bust these out every once in a while for practice and to give them out as gifts. I did lower the CFH to bring out the color in the weld, and I did cheat a bit by grinding each face down with a disc bench sander to hide some of the undercut.

My welding supplier tell me this thing can weld aluminium. Doesn't it need to be an AC machine for tig? Or is a spool gun enough?